Re: Trial 'Fatal error' and no C Drive access
Brilliant, Thank you. Can i ask what part of the traceback you looked at to determine that the graphics were the issue?
View ArticleRe: Trial 'Fatal error' and no C Drive access
Traceback files are encrypted hence it will not make any sense for you if you will open and read that.
View ArticleRe: Trial 'Fatal error' and no C Drive access
Oh right, well thanks again for the quick and accurate response.
View ArticleRe: someone can repair heal the dimples that are corrupted?
Antonius got you mostly there, you should be able to take his models and just draw in the missing balls.
View ArticleRe: someone can repair heal the dimples that are corrupted?
I only have an older version of creo. If you have a version of Solidworks, use that to export a STEP file. Sometimes when I get vendor STEP files, I import it into Solidworks, and that usually...
View ArticleRe: Displaying cosmetic features in detailed views
I avoid cosmetic feaures (except threads) like the plague. I'd use a datum curve instead, much more robust, and as mentioned make a layer for it.
View ArticleClik here to view.
Re: Displaying cosmetic features in detailed views
How annoying! You're right; you can change the view style but not the cosmetic view status. Another Pro|WorkAround^TM to be found. Hang tight
View ArticleClik here to view.
Re: Displaying cosmetic features in detailed views
This would be an aweful work-around...
View ArticleClik here to view.
Clik here to view.
Re: Dimension round up and tolerances in drawing mode
All of it Seriously, right now two things: the dimensions on the drawing don't display rounded up to 3 decimal places by default, I have to edit them;when I edit dimension properties to show the...
View ArticleRe: Mirror Parts don't seem to use a Start Part
You will have to make it like I showed you in WF5 or upgrade to Creo Parametric 2.0.
View ArticleClik here to view.
Re: Dimension round up and tolerances in drawing mode
config.pro - default_dec_places 3 (I use 4 and correct them on the drawing as needed). I don't mess with default tolerances. I leave them at the default 0.1, 0.01, 0.001, and 0.5 degrees. However, be...
View ArticleRe: Window Select parts in a Creo 2 assembly?
This and more : note difference when you draw this box from left-to-right vs. right-to-left :-)You either get "only fully included" or "fully and partially included".
View ArticleRe: Component Sets in Placement Toolbar?
The two major differences between separate SET and just one more constraint is :1. If you use Mechanism Connections you need to add New Set. So if you have Planar and want to add Pin you go to New...
View ArticleClik here to view.
Re: Dimension round up and tolerances in drawing mode
config.pro - default_dec_places 3 (I use 4 and correct them on the drawing as needed). If you set default decimal places to 3, can you still type in a value that goes to 4 decimal places without it...
View ArticleClik here to view.
Re: Dimension round up and tolerances in drawing mode
You are tryin to apply logic to the ways of PTC, aren't you? Yes, internally the values remember your math... where an entry of 5/64 really is .078125 although at 3 places it shows as .078. I don't...
View ArticleRe: Best practices documents?
There are few best-practices; there are some methods people have chosen for consistency in model development. I don't think documentation is the solution. Working with parametric modeling is very...
View ArticleRe: Possible to add radius to sheet metal bend note?
Hello I have just posted exact same question here, but not answered yet. Wondering if you have found solution? RegardsAndy
View Article