ptc-creo using curves and surfaces- units???
Trying to move into a bit more complex drawing. I started playing with the style-curves and surfaces options. After watching a few videos and experimenting with it, it seems like the way to go for...
View ArticleRe: Drawing sections - another oversight?
Thanks Matt. This one worked in selecting the xhatch. Still cannot figure out how to force a "regen" on the -exclude- components.
View ArticleRe: Drawing sections - another oversight?
I am not sure where you are excluding them from?
View ArticleRe: Drawing sections - another oversight?
When editing the xhatch in the drawing, and you select a component, you have the option to -exclude- the component from sectioning if the view is of an assembly.
View ArticleRe: Drawing sections - another oversight?
Oh ok, so I loaded a drawing, went to the assembly section, hit Show on the xhatch (cause I had them all off), and then I go to Properties and it has a component selected, then I Exclude, it updates...
View ArticleRe: Drawing sections - another oversight?
Nope... I have to save, exit, clear memory, and re-open. Creo 2.0 M040.
View ArticleRe: ptc-creo using curves and surfaces- units???
Try using points for creating control geometry.
View ArticleRe: Drawing sections - another oversight?
Ah, interesting. Come to M100 my friend!!!!! hehe, you knew I would say that.
View ArticleClik here to view.
Re: Component Sets in Placement Toolbar?
NEW SET gives you the ability to place the component using a different set of placement constraints. The way I use it is to provide the location(s) of a moving component a location prior to the final...
View ArticleRe: Component Sets in Placement Toolbar?
In later versions the Sets can be used in a family table instead of assembling multiple components and suppressing the ones that aren't used. I'm fairly certain that is the case in Creo 2; though sets...
View ArticleRe: Window Select parts in a Creo 2 assembly?
You can window-select components in assembly, when you set Selection Filter to "Parts". Then you'll be able to draw window around parts you want to select and it'll work as normal 2D selection. You can...
View Articlesomeone can repair heal the dimples that are corrupted?
Please see the attached stp file if you can.
View ArticleClik here to view.
Re: someone can repair heal the dimples that are corrupted?
I was just going to delete them all out and put them back in. But I can not figure out a simple way to get the pattern to work. Can draw in 100+ points, but that's a lot of work.
View ArticleRe: someone can repair heal the dimples that are corrupted?
thank you but sorry I can't do that.
View ArticleClik here to view.
Setting up modelCHECK conditions
I've set up ModelCHECK and everything is work as I want it too. However, I ran in to a bit of a snag. I have this condition for pipe parts unfortunately modelCHECK is not recognizing the model type...
View ArticleClik here to view.
Re: someone can repair heal the dimples that are corrupted?
IDD is -still- a big pain... I got these solid but they are missing a lot of dimples.There really is no rhyme or reason with how IDD is working.But also, the import files really are not very good. Creo...
View ArticleClik here to view.
Re: someone can repair heal the dimples that are corrupted?
This one too is pretty bad. It is now a matter of replacing the missing bumps.
View ArticleRe: Trial 'Fatal error' and no C Drive access
Matthew, This seems to be due to graphics. Check information at http://communities.ptc.com/message/243172#243172 Regarding the config.pro, seems you don't have permission.You can try:1. Copy the...
View Article