Re: Combined View for drawing

Actually I am following the below steps

1)      Created the new part as below



2)      Created the layer states “A” showing Surfacesand “B” in which surface will be hidden as below



3)      Now we have created the COMB001 having layer status “A” andCOMB002 having layer state “B”



4)      And finally I am creating the drawing for this part where while placing the general view of this part, creo will ask that which combined view to be added as below



5)      Here while placing the view first time we selected COMB001 and second time selected COMB002, but both time its shows the same view as below.

Actually I was expecting that in one view it will show the surfaces and in other view it should not but it’s not happening, can you please help on this.