Clik here to view.
Is there a way to fill the hole?
Hi, In creo is there a way to fill the hole? see the attachment.Thanks!
View ArticleClik here to view.
Re: Can someone tell me why this unbend fails?
Change RelativeAccuracy into Absolute Accuracy.see the gif.just click it.
View ArticleClik here to view.
Clik here to view.
How to edit inheritance feature dimensions from drawing level?
I would like to edit model dimensions which were developed using Inheritance from the drawing level. Here is the procedure which I have used for model & drawing creation, First Model with all...
View ArticleRe: How to edit inheritance feature dimensions from drawing level?
See the last response here: http://communities.ptc.com/message/190276#190276
View ArticleClik here to view.
Creo Interface Improvement. Vote.
Hello, I have a Creo interface improvement that is up for voting."Bring all Windchill Pdmlink status information into the Creo interface" Creocentric. http://communities.ptc.com/ideas/4830#comment-15062
View ArticleRe: Creo Interface Improvement. Vote.
Correct link ... http://communities.ptc.com/ideas/4830#comment-15062
View ArticleRe: Anyone Using Windchill PDMLink 10.2 and Creo 3.0
David, in http://support.ptc.com/WCMS/files/67180/en/CreoDataManagementCompatibilityRoadmap_090914.pdf document, you can see info that there is Compatibility with PTC Creo 3.0 F000 & 10.2 M020. But...
View ArticleRe: Anyone Using Windchill PDMLink 10.2 and Creo 3.0
Hi There I think it's to early to install Creo 3.0 ... lot of bugs ... wait release M030 at least
View ArticleClik here to view.
Re: Is there a way to fill the hole?
As written, it depends on what you "tell" creo to treat the inner volume.See attached example (not finished).
View ArticleRe: Schweißnaht--Weldseam
On further testing, you cannot do analysis on reference features which is strange. In this case, you will have to select measure analysis references for all your welds. Below is a video of the...
View ArticleRe: Schweißnaht--Weldseam
I did submit a support case to find out why the reference feature doesn't work for analysis.
View ArticleClik here to view.
Using facet feature as a reference
Hey all, I am new here and just got my hands on Creo 3.0.I have worked on SolidWorks over the period of 4 years so I know a few things about CAD.What pushed me to start exploring creo was that I'm...
View ArticleRe: Can someone tell me why this unbend fails?
The reason the unbend fails, is because of the accuracy.In sheet metal it is recommended to use absolute accuracy (which now is the default for sheet metal parts), and not relative.In this part, the...
View ArticleRe: Is there a way to fill the hole?
Well done! too much broken surfaces.HOPE PTC add FILL SURFACE INTO Creo 3.0.
View ArticleRe: Is there a way to fill the hole?
I was trying to something similar but ran into problems knowing what connected to what.
View Article