Vojtech,
Thanks for the reply. The only problem is that these dimensions do not exist in my case. I didn't think to mention my complete workflow to get to this point. This is a tool to create a part face detail. (It is a mirror image of the part I have to manufacture).
I create the "finished part" part that I need to produce. From there, I use the assembly driven cut-out feature in Creo to add the face detail to my "tool" part. In this case, I projected a sketch in the "finished part" part of the detail before adding corner break radii. Then in my "tool" part, I projected that sketch to form another sketch to show in my "tool" drawing. This method works well as the entire tool set is driven by the specs of the part to be produced.
Thanks,
Matt