Hi Eric, and thank you.
There was no problem with the system, i just upgraded my pc from a singel 128 gb SSD to two drives in raid 0. So no other parts have been changed, Everything elese is just the same as before when Creo did work.
My divice manager dosent show any problems.
After i formatted the old disk I configured the old one and the new one to raid 0 and made a clean installation with a purchased Windows 7 home. All drivers for the motherboard is downloaded from MSI and i don't use any beta drivers.
I tried to open creo both from the shortcuts made by the installation and from the Instalattion folder. I get no response from either place.
Can Creo be a bit delicate to where i install the program? Currently i dont have Creo installed on the same harddrive as Windows, can this be a problem?
Best regards
Marcus